联系电话:

您当前位置:古天乐代言太阳集团>工程动态工程动态

装修不用愁 软膜天花安装方法

太阳集团44118备用址:2017-02-20 14:48:50 发表编辑:phpcms 浏览次数:

软膜天花是一种从国外引进,近年来被广泛使用的室内装饰材料,可配合各种灯光系统来营造梦幻般、无影的室内灯光效果,一般用在大型场合比较多,但也有人喜欢运用在家居餐厅、卧室等地方,下面随小编看看软膜天花安装方法及注意事项。
Soft film smallpox is a kind of interior decoration materials imported from abroad, has been widely used in recent years, with various lighting systems to create a dreamy and shadowless indoor lighting effects, more commonly used in large occasions, but there are also people who love in Home Furnishing restaurant, bedroom place, following small series with soft look ceiling installation method and matters needing attention.
软膜天花安装方法
Soft film ceiling installation method
第一步:软膜天花龙骨安装
The first step: piamater ceiling keel installation
1.根据图纸设计要求,在需要安装软膜天花的水平高度位置四周围固定一圈4X4Cm支撑龙骨(有些地方面积比较大时要求分块安装,以达到良好效果.这样就需要中间位置加一根木方条子)。
1 according to the requirements of design drawings, the position of the height level around the need to install piamater ceiling around a ring of 4X4Cm fixed support keel (some local area is large block installation requirements, in order to achieve good results. This requires the middle position plus a wooden note).
2. 当所有需要木方条子固定好之后,然后在支撑龙骨的底面固定安装软膜天花的铝合金龙骨。
2 when all need wood slivers fixed, and then in the Aluminum Alloy keel support keel bottom fixed installation soft film ceiling.
第二步软膜天花安装:
The second step installation of soft film smallpox:
1、当所有的安装软膜天花的铝合金龙骨固定好以后,再安装软膜。先把软膜打开用专用的加热风炮充分加热均匀,然后用专用的插刀把软膜张紧插到铝合金龙骨上,最后把四周多出的软膜修剪完整即可。
Aluminum Alloy keel 1, when all the installation of soft film smallpox is fixed, and then install the piamater. The film opened with a special heating air full uniform heating, and then use a dedicated knife inserted film tensioning is inserted into the Aluminum Alloy keel, the film can be more around the complete pruning.
2、安装完毕后,用干净毛巾把软膜天花清洁干净。
2 after installation, with a clean towel to clean soft film smallpox.
软膜天花施工注意事项:
Matters needing attention in the construction of soft film smallpox:
1、安装前先到工地现场检查是否有条件安装龙骨,现场墙身是否完成,木工部分加工是否合格,需要抹灰部分先完成,特别注意木工部分一定要按照要求来做,灯、风口等开孔尺寸要提前加工好。
1, before installation to the site to check whether the conditions of the keel wall, the scene is completed, woodworking processing part is qualified, need to pay special attention to the first part of plastering, carpentry part must be in accordance with the requirements to do, to advance the processing hole size, light air etc..
2、现场条件许可方进场施工,首先要按图纸设计要求的木工做好部分进行固定铝合金龙骨龙骨,注意角位一定要直角平整光滑,驳接要平、密。
2, the site conditions permit approach construction, first of all, according to the design requirements of the carpenter to do a good part of the fixed aluminum alloy keel, pay attention to the corner must be smooth and smooth, and then to be flat.
3、注意灯架、风口、光管盘要与周边的龙骨水平,并且要求牢固平稳不能摇摆方可。
3, pay attention to the lamp holder, tuyere, light tube plate and the keel of the surrounding level, and the requirements of a firm and stable can not swing.
4、烟感、吸顶灯,先定位再做一个木底架,木底架底面要打磨光滑,并注意水平高度,太低就容易凸现底架的痕迹。
4, smoke, ceiling lamps, the first position to make a wooden frame wooden chassis underside to polish, and pay attention to the level of height is too low, it is easy to show a trace.
5、安装天花之前,认真检查龙骨接头是否牢固和光滑,喷淋头要粘上白胶带,风口要处理好。
5, before the installation of smallpox, carefully check whether the keel joint is firm and smooth, spray head to stick on white tape, tuyere to handle.
6、安装天花时要先从中间往两边固定,同时注意两边尺寸,注意焊接缝要直最后做角位,注意要平整光滑。四周做好后把多出的天花修剪去除。达到完美的收边效果。
6, the installation of smallpox from the middle to both sides of the first fixed, while the attention of both sides of the size, pay attention to the last straight seam welding angle, pay attention to smooth. After more than four months to do more than the removal of smallpox pruning. To achieve the perfect edge effect.
7、开灯孔要在灯孔的位置上做好记号,把PVC灯圈小心准确地粘在软膜的底面,待牢固后把多出的天花去除即可。
7, turn on the lights to make a mark in the lamp hole hole position, the PVC lamp ring carefully glued to the bottom surface of piamater accurately, to be strong after the removal of smallpox can be.
8、开风口、光管盘口处理就是找到风口光管盘口的位置,跟做四周一样,把软膜安装到铝合金龙骨上,注意角位要平整。做好后把多出的天花切除即可。
8, open the outlet, is to find the location of the light pipe outlet handicap handicap light tube, like around the soft film mounted to Aluminum Alloy keel, note the angle should be smooth. After the completion of the smallpox can be removed.
9、最后用干净毛巾清洁软膜天花表面。
At the end of 9, with a clean towel to clean the surface of soft film smallpox.
软膜天花具有具有防火、防菌、防水、节能、环保、抗老化、安装方便等多种优点,所以越来越成为室内吊顶材料的首选,喜欢这种新型独特的吊顶天花的不妨多了解下。
With a soft film smallpox with fire prevention, waterproof, anti bacteria, anti ageing, environmental protection, energy saving, convenient installation and many other advantages, so more and more become the preferred indoor ceiling materials, this unique new love may wish to know more about the suspended ceiling.
编辑总结:关于软膜天花安装方法的相关信息就为大家先容到这里了,希翼这篇文章对大家有所帮助。如果大家还有什么不明白的地方可以在下方给小编留言哦,大家会尽快为您解答。
Edit summary: information about soft film smallpox installation method to introduce here, this article hopes to help you. If you do not understand what can be left to the bottom of the small message Oh, we will answer for you as soon as possible.
XML 地图 | Sitemap 地图